12. OPERATION 12.2.2 STARTING IN COLD WEATHER (when using APS) When starting the engine in cold weather, do as follows. WARNING If a starting aid fluid is used, there is danger of an explosion. Never use any starting aid fluid. NOTICE Do not keep the starting motor rotating continuously for more than 20 seconds. If the engine will not start, wait for at least 2 minutes, then repeat Steps 2 to 8. 1. Open fuel valve 1 of the starting aid. NOTICE During cold weather (below 15°C), keep fuel valve 1 of the starting aid open. 2. Turn the key in starting switch 2 to the ON position.
NOTICE If this step is not carried out and the operation is carried out using Steps 4 to 8, the service life of the nozzle will be reduced, so always carry out Step 2. 3. Keep fuel cut switch 5 pressed, turn starting switch 2 to the START position, and crank the engine for approx. 10 seconds. After finishing, put starting switch 2 to the ON position. 4. Release fuel cut switch 5 . The switch will automatically return. 5. Keep APS switch 3 pressed up to Step 10. After a short time, preheating monitor 4 will light up. When it lights up, the APS function automatically starts. 2-65