26. HANDLING PAYLOAD METER CARRYING OUT SENSOR CHECK 1. Drive the machine unloaded on flat ground. 2. Set the shift lever to N and press calibration switch 1 for at least 2 seconds, then press calibration switch 1 again for at least 2 seconds. (The letters SCH will flash) 3. When traveling at a speed of approx. 10 km/h (6.2 MPH), press calibration switch 1 again. (The letters SCH will light up) If the display returns to the time display, the operation is completed. If there is an abnormality in any sensor, the error code is displayed. AD134720 Carry out the sensor check at least once every month. PRINTING OUT 1.
When print out switch 1 is pressed for at least 2 seconds, the data are printed out. To stop the print during the printout, press the print switch again for at least 2 seconds. Do not hold the paper coming out from the printer during the printout. This will cause the print to overlap. 2. When print feed switch 2 is pressed for at least 2 seconds, the paper is fed. AD134730 DELETING DATA FROM MEMORY 1. Print out the necessary data before clearing the memory. 2. Press memory data clear switch 1 for at least 2 seconds. (The letters CLEA will flash) 3. Press memory data clear switch 1 again for at least 2 seconds to completely clear the memory.
AE134740 After completion of operations, we recommend that you stop the machine, print out the data, and clear the data from memory. 5-7