26. HANDLING PAYLOAD METER 3. Remove the connectors, remove the screws (top: M4 x 8, rear: M4 x 3) of top cover 1 of the payload meter, then remove top cover 1 . M4X8 M4X3 AE134820 4. Use tweezers to remove the paper caught between printer head 2 and guide 3 . Do not wear gloves when carrying out this operation. When using tweezers to remove the jammed paper, press the guide with your finger to make a clearance between the printer head and guide to make it easier to remove the paper. If there is any paper remaining immediately under the printer head, turn gear 4 with the flat of your fingers to move the head. If gear 4 is turned counterclockwise, the head will move to the right. 5.
After removing the paper, install the connectors before installing the top cover. 6. Remove the printer paper remaining inside the printer, and cut the leading end of the paper. For details of the method of cutting the end of the paper, see “Method of cutting printer paper”. 7. Turn the starting switch key to the ON position, and press the FEED switch. For details of the method of inserting the paper, see “Setting paper in printer”. 8. Turn the starting switch key to the OFF position, remove the connectors, then assemble to the original condition. 5-13