11. EXPLANATION OF COMPONENTS 5. FRONT BRAKE OFF SWITCH WARNING When traveling on icy roads, on snow, or on other slippery road surfaces, it is necessary to control the steering, so set the front brake switch to the k position (ON) and travel slowly at a safe speed. The braking method can be selected according to the road surface conditions. i position (OFF): When the brake pedal is depressed, the brakes are applied to both the front and rear wheels. k position (ON): When the brake pedal is depressed, the front brakes are not applied. The brakes are ap- plied only to the rear wheels. 6. HAZARD LAMP SWITCH This flashes the left- and right-hand turn signal lamps.
When the switch is turned on, the turn signal pilot lamp flashes at the same time. If the starting switch is OFF, the turn signal pilot lamp does not flash. 7. NIGHT LIGHTING DIMMER SWITCH This is used to adjust the brightness of the monitor panel lighting and pilot lamps. Turn to the right to make the lighting brighter and turn it to the left to make the lighting dimmer. Decrease Increase AE61609B 8. FUEL CUT SWITCH NOTICE Do not operate this switch when the engine is running (when the machine is traveling). This cuts the supply of fuel to the engine. It is used when starting the engine using the APS (starting aid) in cold weather. OFF: No fuel is supplied to the engine ON:
Fuel is supplied as normal REMARK If the switch is released when it is at the OFF position, it will return to the ON position. For details of the method of using the fuel cut switch, see “12.2.2 STARTING IN COLD WEATHER”. 2-20