11. EXPLANATION OF COMPONENTS 11.4 MECHATRONICS EQUIPMENT CONTROLLER 1. SHIFT CONTROLLER A two-digit number followed by the action code is displayed in the inspection window to identify the location of the abnormality. When the condition is normal, “0.0” or “0.C” is displayed. 2. ENGINE CONTROLLER A two-digit number followed the action code is displayed in the inspection window to identify the location of the abnormality. When the condition is normal, “0.0” is displayed. 3. SUSPENSION CONTROLLER A two-digit number followed the action code is displayed in the inspection window to identify of the location of the abnormality. When the condition is normal, “0.0” is displayed. 4.
APS CONTROLLER A green and red LED (Light Emitting Diode) are installed inside the inspection window. These go out, flash, or light up in combina- tion to indicate the location of the failure. For detail of the display when an abnormality occurs, see “16. TROUBLESHOOTING”. 11.5 SAFETY PIN WARNING When raising the dump body to inspect the machine, always place the dump lever at the HOLD position, apply the lock, and then use the safety pins. This is a safety device for the dump body, and is used when carrying out inspection and maintenance or when operating with the dump body raised. Raise the dump body fully, insert safety pins 1 . Always insert the safety pins on both sides.
STOWING SAFETY PIN The safety pins are stowed at the bottom rear of the dump body. Insert safety pins 1 , then insert lock pins 2 to stow in position. 2-29