TM2361 (24JUN08) 9015-15-7 450DLC Excavator Operation and Tests 062608 PN=451 Sub-System Diagnostics The preheat circuit helps with engine starting and Unswitched power from the battery is available at idling during cold starting conditions. Using the preheat terminal 1 of glow plug relay (K16). When key switch circuit helps reduce white smoke and engine noise (S1) is turned to the ON position, power becomes when starting, and helps the engine idle upon starting. available to terminal 3 (coil) of the glow plug relay, The preheat circuit consists of the following through fuse (F16). If the ECM senses that the engine components:
coolant temperature is less than 20°C (68°F), the ECM connects terminal V10 to ground, which provides a • Batteries (G1 and G2) path to ground for terminal 4 (coil) of the glow plug • Battery relay (K19) relay, energizing the relay. With the glow plug relay • Key switch (S1) energized, high current is allowed to flow directly from • Engine control module (ECM) (A1) the batteries to glow plugs (R1—R6), causing the glow • Monitor controller (A4) plugs to create heat.
• Engine coolant temperature sensor (B4) • Glow plug relay (K16) During the time the preheat circuit is energized, the • Glow plug relay diode (V1) ECM sends a signal out ECM terminal V11 to the • Glow plugs (R1—R6) terminal B10 on the monitor controller (A4), causing the engine preheat indicator to appear on the monitor The preheat system uses six glow plugs, one for each display. cylinder, to heat the air in the precombustion chamber of each cylinder. The preheat system is controlled by For more information on the monitor controller, see the ECM, which uses information from engine coolant Monitor Circuit Theory of Operation.
(Group 9015-15.) temperature sensor (B4) to determine if the preheat circuit is needed. The ECM will automatically enable For more information on the engine control module, the preheat circuit when key switch (S1) is turned to see Engine Control Module (ECM) Theory of the ON or START position and the engine coolant Operation. (Group 9015-15.) temperature is less than 20°C (68°F). During the time the preheat circuit is energized, the engine preheat indicator will appear on the monitor display. LD30992,000020F –19–19APR06–2/2 9015 15 7