John Deere 450DLC — Monitor Circuit Theory of Operation

TM2361 (24JUN08) 9015-15-11 450DLC Excavator Operation and Tests 062608 PN=455 Sub-System Diagnostics Specification (terminal V67). The varying signal represents the Fuel level sensor (B18)— varying resistance of the engine oil pressure sensor Resistance.............................................. 90—100 ohms (tank empty) corresponding to the changing engine oil pressure. 82—88 ohms (warning level) High resistance of the sensor indicates a low pressure. 53 ohms (tank 1/4 full) 33—43 ohms (tank 1/2 full) When engine oil pressure is not to specification, the 26 ohms (tank 3/4 full) ECM connects terminal B16 on the monitor controller 6—10 ohms (tank full) to ground.

This causes the engine oil pressure indicator to appear on the monitor display. For Auto-Idle Indicator—When auto-idle switch (S8) is in information on diagnosing ECM circuit malfunctions, the ON position, terminal B18 on the monitor controller see Engine Control Module (ECM) Diagnostic Trouble is connected to ground. This causes the auto-idle Codes. (Group 9001-20.) indicator to appear on the monitor display. For additional information on auto-idle, see Main Controller Alternator Indicator—Voltage from terminal L of (MCF) Circuit Theory of Operation (Group 9015-15.) or alternator (G3) is applied to the monitor controller (at see Engine Speed Control System Operation. (Group terminal C7).

If the voltage is too low, or if the 9010-05.) alternator does not generate any voltage at all, the alternator voltage indicator appears on the monitor Preheat Indicator—When preheating is required, the display. For additional information on the charging ECM connects terminal B10 on the monitor controller system, see Starting and Charging Circuit Theory of to ground. This causes the preheat indicator to appear Operation. (Group 9015-15.) on the monitor display. For additional information on the preheat circuit, see Quick On System (QOS) Remaining Fuel Indicator—Fuel level sensor (B18) Preheat Circuit Theory of Operation.

(Group 9015-15.) sends a varying signal to the monitor controller (terminal C2). The varying signal represents the NOTE: For identification of monitor controller alarm varying resistance of the fuel level sensor indicators, see Alarm Occurrence Screen. corresponding to the changing fuel level. When fuel (Operator’s Manual.) level becomes too low, the remaining fuel indicator appears on the monitor display. Overheat Indicator—When the engine coolant reaches too high a temperature, engine coolant Specification temperature switch (B19) closes. This connects Fuel level sensor (B18)— terminal B5 on the monitor controller to ground, Resistance.............................................

82—88 ohms (warning level) causing the overheat indicator to appear on the monitor display. Hydraulic Oil Filter Indicator—When the hydraulic oil filter is clogged, hydraulic oil filter restriction switch Engine Warning Indicator—When the ECM detects (B27) connects terminal B15 on the monitor controller an abnormality, it connects terminal C11 on the to ground. This causes the hydraulic oil filter restriction monitor controller to ground. This causes the engine indicator to appear on the monitor display. warning alarm indicator to appear on the monitor display.

For information on diagnosing ECM circuit Air Filter Clogged Indicator—When air filter elements malfunctions, see Engine Control Module (ECM) are clogged, air filter restriction switch (B16) connects Diagnostic Trouble Codes. (Group 9001-20.) terminal B4 on the monitor controller to ground. This causes the air filter clogged indicator to appear on the Engine Oil Pressure Indicator—Engine oil pressure monitor display. sensor (B11) sends a varying signal to the ECM Continued on next page CS33148,00008E9 –19–21APR06–4/6 9015 15 11