John Deere 450DLC — Engine Control Module (ECM) Circuit Theory of Operation

TM2361 (24JUN08) 9015-15-15 450DLC Excavator Operation and Tests 062608 PN=459 Sub-System Diagnostics NOTE: When engine control module (A1) detects an • Preheat abnormality, it connects terminal V6 to ground. • Exhaust Gas Recirculation (EGR) This provides a ground path to terminal C11 • Engine Stop on monitor controller (A4), causing the engine warning alarm indicator to appear on the NOTE: For additional information on the fuel system, monitor display. For information on diagnosing see Engine Fuel System Operation. (Group engine control module circuit malfunctions, see 9010-05.) Engine Control Module (ECM) Diagnostic Trouble Codes.

(Group 9001-20.) Fuel Injection Control—The ECM controls fuel injection pressure, amount, and timing by sending the The alarm data will be recorded in the appropriate pulse width modulated (PWM) signals to information controller (ICF). For information on the electronic injectors (Y1—Y6) and fuel pump control the ICF, see Information Controller (ICF) valve solenoids (Y15 and Y16). Theory of Operation.

(Group 9015-15.) Electronic Injectors—When the key switch is in the ON Engine control module (A1) determines key switch (S1) or START position, the ECM provides power electronic is in the ON position when current flows from fuse injectors 1—3 (Y1—Y3) at terminal E121 and to (F18) to terminal V24. When the key switch is in the electronic injectors 4—6 (Y4—Y6) at terminal E116. ON position, the ECM energizes ECM relay (K14). The energized ECM relay allows current to flow from fuse The ECM activates the electronic injectors by (F8) to terminals V2 and V5, providing the ECM with connecting the corresponding terminal of each injector main power. to ground:

The ECM receives signals from the following • Electronic injector #1 (Y1) (terminal E119) components:

• Electronic injector #2 (Y2) (terminal E114) • Electronic injector #3 (Y3) (terminal E117) • Main Controller (A3) • Electronic injector #4 (Y4) (terminal E115) • Crankshaft Position Sensor (B1) • Electronic injector #5 (Y5) (terminal E120) • Camshaft Position Sensor (B2) • Electronic injector #6 (Y6) (terminal E118) • Barometric Pressure Sensor (B3) • Engine Coolant Temperature Sensor (B4) Fuel Pump Control Valve Solenoids—When ECM relay • Fuel Temperature Sensor (B5) (K14) is energized, power is available to fuel pump • Intake Air Temperature Sensor (B7) control valve solenoids 1 and 2 (Y15 and Y16) from • Boost Temperature Sensor (B10) fuse (F14).

The ECM activates fuel pump control valve • Engine Oil Pressure Sensor (B11) solenoid 1 (Y15) by connecting terminals E105 and • Fuel Rail Pressure Sensor (B12) E113 to ground. The ECM activates fuel pump control • Exhaust Gas Recirculation (EGR) Position Sensor valve solenoid 2 (Y16) by connecting terminals E89 (B60) and E97 to ground. • Engine Stop Switch (S14) Position Sensors—Crankshaft position sensor (B1) After processing the received signals, the ECM sends detects engine speed. The crankshaft position sensor signals to various components to control the following is installed on the flywheel housing and sends a signal functions:

to the ECM (terminals E106 and E107) when the convex portion of the flywheel passes the sensor. • Fuel Injection Continued on next page CS33148,00008EA –19–21APR06–2/4 9015 15 15