John Deere 450DLC — Pump 1 and 2, Fan Drive Pump, and Gearbox Operation

TM2361 (24JUN08) 9025-05-33 450DLC Excavator Operation and Tests 062608 PN=671 Theory of Operation 16—Pump 2 29—Fan Drive Pump Regulator 202—Cylinder Block 206—Swash Plate 18—Pump 2 Regulator 30—Servo Piston 203—Piston 207—Drive Gear 19—Servo Piston 200—Tilt Pin 204—Shoe 208—Drive Shaft 28—Fan Drive Pump 201—Valve Plate 205—Shoe Plate Pump 1, pump 2, and fan drive pump operation is the the drive shaft (208). Increasing the angle increases same except as noted. Pump 2 and fan drive pump the distance that each piston (203) travels into and out are shown. Pump 2 operation is given. of the bore of the cylinder block (202), which increases pump displacement. Decreasing the angle reduces the NOTE:

Pump 1 drive shaft carries the driven gear distance that each piston travels into and out of the while pump 2 drive shaft carries the drive gear, bore of the cylinder block, which decreases pump which drives pump 1 and the fan drive pump. displacement. The pilot pump is driven off the end of pump 1 drive shaft. An attenuator hose is connected from each pump discharge port to a blocking plate attached to the The pump 2 regulator (18) is attached to the top of the machine frame. The pump 1 and pump 2 attenuator pump housing. The regulator controls the movement of hoses help reduce pump noise and vibration during the servo piston (19) by sending or releasing oil from operation.

the large end of the piston. The servo piston moves the tilt pin (200) and swash plate (206), changing the For more information, see Pump 1, Pump 2, and Fan pump displacement. Drive Pump Regulator Schematic. See Hydraulic System Schematic. (Group 9025-15.) See Pump 1 and The pump displacement (pump flow rate) is varied by Pump 2 Regulator Operation. See Fan Drive Pump changing the angle of the swash plate with respect to Regulator Operation. (Group 9025-05.) LD30992,0000257 –19–11APR06–3/3 9025 05 33