John Deere 450DLC — Main Relief and Power Digging Valve Circuit Operation

TM2361 (24JUN08) 9025-05-68 450DLC Excavator Operation and Tests 062608 PN=706 Theory of Operation 23 24 25 26 21 27 28 85 –UN–12APR06 TX1006227 TX1006227 Power Dig Circuit Operation 21—Pilot Oil 25—Power Dig Switch 28—Voltage 85—Main Relief and Power Dig 23—Travel Right 26—Main Controller (MCF) Valve 24—Travel Left 27—Power Dig Solenoid Valve SG Power Dig Circuit Operation—The function of the valve SG pushes the piston in the main relief and power dig control circuit is to temporarily increase the power dig valve down, increasing the pressure setting.

9025 05 68 main hydraulic system operating pressure by increasing the main relief and power dig valve (85) The main hydraulic system can now operate at a pressure setting. higher operating pressure for approximately 8 seconds as long as the power dig switch is held down. If the When the power dig switch (25) is pushed and held or switch is released before 8 seconds, the power dig when a travel function (23 or 24) is actuated, the main function is turned off. After 8 seconds, the switch must controller (MCF) (26) sends an electrical signal to be released and pushed again to actuate the power energize the power dig solenoid valve SG (27). The dig function.

The length of time the power dig function pilot oil pressure signal from the power dig solenoid is actuated is controlled by a timer circuit in the MCF. Continued on next page LD30992,000025C –19–13APR06–3/6 85 85