TM2361 (24JUN08) 9025-05-109 450DLC Excavator Operation and Tests 062608 PN=747 Theory of Operation Boom, Arm, and Bucket Cylinder Operation –UN–25APR06 TX1007001 Cylinder Operation 1—Snap Ring 6—Wear Ring 10—Wear Ring (2 used) 14—Cushion 2—Wiper Seal 7—Snap Ring 11—Cap Seal 15—Barrel 3—Back-Up Ring 8—Piston 12—Set Screw 16—Cylinder Rod 4—U-Cup Seal 9—Buffer Ring (2 used) 13—Nut 17—Rod Guide 5—Buffer Ring Boom, Arm, and Bucket Cylinders— loosening of the nut. The piston is fitted with a cap seal (11), wear rings (10), and buffer rings (9). The boom, arm, and bucket cylinders are similar in design. The bucket cylinder is illustrated.
The rod Boom, bucket, and arm cylinders have a cushion (14) guide (17) is fastened to the cylinder barrel with cap in front of the piston to provide cushioning action in screws and is fitted with a wear ring (6) held in place cylinder extension. As the cylinder nears the end of its by a snap ring (7). A buffer ring (5), U-cup seal (4), stroke, the cushion enters a bore in the rod guide. The back-up ring (3), and wiper seal (2) are used in the rod remaining return oil ahead of the piston must flow guide. A snap ring (1) is used to help hold wiper seal through a small clearance between the cushion and in place. The U-cup seal (4) is protected against high rod guide.
Only the arm cylinder is cushioned in pressure by the buffer ring (5) and stops the small retraction. The end of the rod enters a bore in the amount of oil that may pass by the buffer ring. head end of cylinder. The remaining return oil ahead of the piston and nut must flow through this small The piston (8) is a slip fit on the cylinder rod (16) and clearance as the cylinder bottoms out in this direction. is retained with a nut (13). A set screw (12) prevents LD30992,000026B –19–25APR06–1/1 9025 05 ,109