Diagnostic Information All Functions Slow Diagnostic Procedure –1/1 TM2361 (24JUN08) 9025-15-15 450DLC Excavator Operation and Tests 062608 PN=765 1 Restricted Pilot Filter Check Inspect pilot filter. Is pilot filter free of restriction? YES: Go to Actuating Pilot Pressure Check. NO: Replace pilot filter. See Replace Pilot System Oil Filter. (Operator’s Manual.) – – –1/1 2 Actuating Pilot Pressure Check Key on, use monitor service menu to display Swing / Attachment Control Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: Spool actuating pressure can be checked for each function by installing a tee and gauge in pilot line and then actuating that function.
Perform Control Valve Spool Actuating Pilot Pressure Test. (Group 9025-25.) Run engine at fast idle and operate problem function. Observe pressure when function held over relief. Is pilot pressure above 3.70 MPa? YES: Go to Pilot Shutoff Solenoid Valve Check. NO: Adjust, repair or replace pilot pressure regulating valve. See Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) NO: Pilot pump worn. Inspect, repair or replace pilot pump. See Pilot Pump Remove and Install. (Group 3360.) – – –1/1 9025 15 15 3 Pilot Shutoff Solenoid Valve Check Inspect pilot shutoff solenoid valve for restriction. Is pilot shutoff solenoid valve free of restriction? YES:
Diagnostic procedure complete. NO: Repair or replace pilot shutoff solenoid valve. See Pilot Shutoff Solenoid Valve Disassemble and Assemble. (Group 3360.) – – –1/1