John Deere 450DLC — Boom Mode Solenoid Valve (port SC) Test and Adjustment

TM2361 (24JUN08) 9025-25-27 450DLC Excavator Operation and Tests 062608 PN=887 Tests Example of Calculated Reading From Monitor Actuated Neutral Example of 3.23 MPa 0.0 MPa Calculated Reading 3230 kPa 00 kPa From Monitor 32.3 bar 0.0 bar 468 psi 00 psi LD30992,00002B0 –19–05JUN06–4/5 9. Adjust the solenoid valve (H) as needed. a. Loosen nut (J). IMPORTANT: Turning adjusting screw out too far may cause oil leakage because the O-ring –UN–20JUN96 has come off its seat. b. Turn adjusting screw (I) in to increase actual pressure reading; turn adjusting screw out to T101709 decrease pressure reading. The length from end of adjusting screw to nut must not exceed the specified length.

H—Solenoid Valve I—Adjusting Screw Specification J—Nut Solenoid Valve Adjusting Screw— Pressure Change..................................... 0.069 MPa approximate per 1/4 turn 69 kPa approximate per 1/4 turn 0.69 bar approximate per 1/4 turn 10 psi approximate per 1/4 turn End of Adjusting Screw-to-Nut— Length............................................................................... 2 mm maximum 0.079 in. maximum c. Hold adjusting screw and tighten nut. Specification Solenoid Valve Adjusting Screw-to-Housing Nut—Torque.................................................... 3.0 N•m 27 lb-in. 10. Check the pressure setting again.

LD30992,00002B0 –19–05JUN06–5/5 9025 25 27 Example of Calculated Reading From Monitor Actuated Neutral Example of Calculated Reading From Monitor 3.23 MPa 3230 kPa 32.3 bar 468 psi 0.0 MPa 00 kPa 0.0 bar 00 psi