John Deere 450DLC — Main Relief and Power Digging Valve Test and Adjustment

TM2361 (24JUN08) 9025-25-35 450DLC Excavator Operation and Tests 062608 PN=895 Tests NOTE: A pressure setting that cannot be raised can be 1 caused by a low pressure setting of the circuit relief valve. Use boom up and the other propel 2 function for adjusting the main relief and power 3 digging valve. See Circuit Relief Valve Test and Adjustment to check the circuit relief valve that is low. (Group 9025-25.) 4 7. Adjust the main relief and power digging valve pressure setting as needed. 5 Specification Main Relief Valve—Pressure...........................................

30.4—32.9 MPa 30 400—32 900 kPa 304—329 bar 4410—4770 psi 6 Specification –UN–01FEB06 Power Digging Valve—Pressure...................................... 32.8—35.3 MPa 32 800—35 300 kPa 328—353 bar 4770—5120 psi TX1003242 8. Loosen the 30 mm nut (2). 9. Turn first adjusting plug (1) in until piston (5) is against Main Relief and Power Digging Valve shoulder (6) in second adjusting plug (3). Tighten nut 1—First Adjusting Plug finger tight. 2—30 mm Nut 3—Second Adjusting Plug 10. Loosen the 41 mm nut (4). 4—41 mm Nut 5—Piston 11. Actuate the propel function over relief. 6—Shoulder 12.

Turn second adjusting plug (3) in to increase power digging relief pressure; turn adjusting plug out to decrease pressure. Specification Second Adjusting Plug—Pressure Change................................................. 4.5 MPa approximate per 1/4 turn 4500 kPa approximate per 1/4 turn 45 bar approximate per 1/4 turn 655 psi approximate per 1/4 turn 13. Hold second adjusting plug. Tighten 41 mm nut to specification. Specification 41 mm Nut—Torque....................................................................... 98 N•m 70 lb-ft Continued on next page LD30992,0000280 –19–05JUN06–5/6 9025 25 35