MBE 900 ENGINE 2007 OPERATOR'S GUIDE 1. Chock the tires, place the transmission in neutral, and set the parking brake. edge of the filter element to the side. See Figure 35. NOTE: Change the engine oil only when the engine is at an operating temperature of approximately 82°C (180°F). 2. Using a 36-mm socket, unscrew the oil filter cap and allow the oil to drain out of the housingSee Figure 34. Figure 35 Cap with Oil Filter Element 5. Inspect the inside of the filter housing to ensure there is no debris. 6. Replace the O-ring on the cap. See Figure 35. Figure 34 Oil Filter Cap 7. Install the new filter into the cap. Make sure the filter element is securely in place. 3.
Place a suitable receptacle beneath the oil drain plug on the underside of the oil pan. Carefully unscrew the oil drain plug on the oil pan and allow the oil to drain out. Discard the O-ring on the oil drain plug. 8. Screw the cap onto the oil filter housing. Tighten the cap 25 N·m (18 lb·ft). 9. Install the oil drain plug, using a new O-ring. Tighten the plug 65 N·m (48 lb·ft). 4. Remove both the filter cap and the filter element. To release the filter element, twist the lower 10. Add new engine oil through the oil fill hole on the cylinder head cover.(see Figure 36). All information subject to change without notice. (Rev.
04/08) 91 DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION