MBE 900 ENGINE 2007 OPERATOR'S GUIDE or higher. Charge the battery, if necessary. NOTE: The small amount of rust preventive which remains in the fuel system will cause smoky exhaust for a few minutes. 10. Service the air cleaner, if required. 11. Transmission: Follow the manufacturer's recommendations covering the return of the transmission to service. NOTE: Before subjecting the engine to a load or high speed, allow it to reach normal operating temperature. Then check for trouble codes. 12. Power Take-Off: If equipped, follow the manufacturer's recommendations covering the return of the power take-off to service. 13. Turbocharger:
Remove the covers from the turbocharger air inlet and turbine outlet connections. Reconnect piping as required. Prelube the turbocharger center bearing housing. Refer to Lubrication System Checks in the OPERATING INSTRUCTIONS FOR STARTING THE ENGINE section of this guide. To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. ENGINE EXHAUST 14. After all preparations are completed, start the engine. All information subject to change without notice. (Rev. 04/08) 137 DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION