MBE 900 ENGINE 2007 OPERATOR'S GUIDE The activation conditions are listed in Table 5. Table 5 Lamp Activation Conditions All information subject to change without notice. (Rev. 04/08) 69 DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION Lamp Lamp Solid Lamp Flashing □ At the start of every ignition cycle (a bulb check). □ When an electronic system fault occurs (problem should be diagnosed as soon as possible). □ Diagnostic Request Switch is used to activate the AWL to flash inactive codes. □ Last 90 seconds before idle shutdown if programmed for override. □ Idle shutdown or the Optimized Idle shutdown occurs. □ At the start of every ignition cycle (a bulb check).
□ A potential engine damaging fault is detected. □ When Engine Protection Shutdown occurs. □ Diagnostic Request Switch is used to activate the RSL to flash active codes. □ Parked regeneration is required. □ At the start of every ignition cycle (a bulb check). When a parked regeneration is required immediately (If the lamp flashing is ignored, derate and/or shutdown could occur. □ At the start of every ignition cycle (a bulb check). □ Vehicle speed is less than 5 mph and the DPF outlet temperature is greater than 525°C (977°F). Flashes every 10 seconds during a parked regen □ At the start of every ignition cycle (a bulb check).
□ For any emission related fault (light out when the fault is inactive) Never flashes