. OPERATION OPERATION OPERATION OPERATION REMARK 3 - 109 2. Depress accelera 3. When preheating pilot lamp (2) goes out, to the START position. tarting switch (1) at the ST turn the key in ART position to ne starts. in starting switch (1) Keep the key in s keep the starting motor running until the engi 4. The starting moto r will continue to turn and the engine will start. REMARK to ensure lubrication of the engine and to y, no fuel is supplied to the engine for 3 In lo w temperatures, to improve the durabilit he engine for 3 seconds after the key in starting switch (1) is turn ed to the START position, so the engin e will not start during this ti me.
Therefore, keep the k ey in starting switch (1) at the START position to keep the starting m otor running until the engin e starts. 5. Method of starting engine in temperatures of approx. -20°C (-4 °F). 1) Keep the eng (1) in the STA 2) If the engine f engine startin a pause for a 3) If the engine s for a minute o 1) Keep the eng ine starting motor running fo r the max. 20 seconds, holding the key of e ngine starting switch RT position, until the engin e starts up.
unning the engine starting motor for about 20 seconds, stop the 2) If the engine f ails to start up even after r unning the engin g motor once (release the e ngine starting switch key), and try the same process again after minute or so. 3) If the engine s till fails to start up after the se cond attempt, try the same process for the th ird time after a pause r so. 6. When the engine has started up and the eng ine speed rises, r elease the key of engine starting switch ( rn to the ON position. 1). The key will will automatically retu 7. Keep stepping on accelerator pedal (3) until t he engine is fully r unning. Kee p, until engine warming- up run is finished. Do not s tep on the pedal to th