. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE come out with Tightening torque: 7.8 to 9.8 Nm (0.8 to 1 kgm , 5.8 to 7.2 lbft) CHECK TRANSMISSION OIL LEVEL, ADD OIL WARNING 4 - 25 13. Loosen ai r bleed plug (5) of the fuel fi 14. Pump prim ing pump (6) u the fuel fro Tighten ai m air bleeder ( r bleed plug (5). The parts and oi l are at high temp erature immediately a fter the e ngine is stopped, and may cause b urns. Wait for the temperature to go down befo re starting the w ork. Carry out this procedure if the re is any sig n of oil on the transmission case, or if there is oil mixed with the cooling water 1. Start the e ngine and run i t for at least 5 minu 2.
Open the cap of oil filler po rt (F), remo ve dipst ick (G), and wipe the oil off with a cloth. 3. Fully inser t dipstick (G) in to filler pipe, then re move it 4. The oil lev el should be be tween the H and L marks o n dipstick (G). If the oil le vel is below the L mark, ad d oil thr ough oil filler port (F). 5. If the oil is above the H m ark, drain th e exces s engin e oil from drain plug (P), and check the oil level again. If the oil le then tighte