MACHINE OPERATIONS AND CONTROLS 5. Set safety lock lever (3) in the LOCK position. NOTE For machines equipped with a cab, there is only a safety lock lever on the left. 3.3.15 CHECK AFTER SHUT OFF ENGINE Check the engine water temperature (1), engine oil pressure (2), and fuel level (3) on the machine monitor. 3.3.16 MACHINE INSPECTION AFTER DAILY WORK 1. Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for any leakage of oil or coolant. If any abnormalities are found, repair them. 2. Fill the fuel tank. 3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard. 4.
Remove any mud affixed to the undercarriage. 3.3.17 LOCKING Always lock the following places. (1) Operator's cab door (machines equipped with cab) Always close the windows. (2) Engine rear cover (3) Fuel cap (4) Operation and Maintenance Manual, toolbox cover For further details, see paragraph "3.2.8 CAPS AND COVERS WITH LOCK". NOTE Use the starting switch key to open and close all these plac- es. 129