D 2008/2009 Fuel system W 07-04-01 z Push fuel injector toothed wheel (4) onto fuel injector shaft. Attention! The marks of the fuel injector toothed wheels and the idler gear must be in line. z Push the measuring pin (3) through the marking hole into the crankcase. z Mount washer (2). z Mount nut (1). z Tighten nut (1). 10 Nm 6 z Loosen blocking screw (1). z Push locking ring (2) towards smaller opening. Attention! Loosening the blocking screw releases the blocking of the fuel injector shaft. Never start the engine with the fuel injector shaft blocked! 1 2 z Tighten blocking screw. 10 Nm z Tighten nut of fuel injector toothed wheel. 81 Nm z Remove measuring pin.
© 41143-0 z Mount gearcase cover. W 04-04-09 z Mount high pressure pipes. z Screw on union nuts. Attention! Install injection pipes without tension. z Tighten union nuts. 28 Nm z Position pipe clip. z Tighten screw. 9 Nm © 41093-1 © 02/2006 6011-001 4/4 4 3 2 1 © 41147-0 © 41147-0