Optional Equipment - Section 7 OM7001 Page 7-2 Cab Radio When the receiver is in the cassette mode, the display will toggle between TP SIDE 1 or TP SIDE 2, and the clock. Manual Tuning: Press TUNE (8) to tune to the next higher frequency. Press SEEK (7) to tune to the next lower frequency. Holding either of the buttons for more than 0.5 seconds will activate fast tuning for increased speed. SETTING THE DEFAULT DISPLAY 1. Press and hold DSPL/TM (9) for 2 seconds until the hour digits flash. Seek Mode: In seek mode, the receiver will only stop on stations that have a strong signal. To scroll through these stations, press TUNE (8) for at least 0.5 seconds to activate seek mode.
The receiver will move to the next highest frequency and pause for 3 seconds. After 3 seconds, the receiver will move to the next higher frequency. This pattern will continue until the TUNE button is pressed again. Press SEEK (7) for at least 0.5 seconds to activate seek mode for the next lower frequency station. The receiver will momentarily stop on strong stations until the SEEK button is pressed again. 2. Press push-button 6/FF (15) to change the default display. After 5 seconds of inactivity has elapsed, the selected default will display. ADJUSTING DISPLAY BRIGHTNESS 1. Press and hold DIM (14) until "DIM" appears on the display. 2.
Rotate ON/AUDIO knob (6) clockwise or coun- terclockwise until the desired brightness is obtained. NOTE: If the receiver can not find a strong enough signal after two band cycles, the seek mode will discontinue and the receiver will return to the initial station. OPERATING THE RADIO SCAN (10): Press the SCAN button to scan all stations on the current band. When a strong frequency is found, the receiver will pause on that station for about 5 seconds and then continue scanning. Scan will appear on the display along with the frequency when this mode is active. To stop scanning, press the SCAN button again. BAND (2): Press Band (2) to switch between FM1, FM2, AM, and WX Weather (US).
TUNE / SEEK (7 & 8): Allows you to move up or down in frequency to other stations. There are two modes of operation for finding other stations, manual tuning and seek mode. Press and hold both TUNE (8) and BAND (2) for 2 seconds to toggle between the two modes. The display will read either "MANUAL" or "SEEK" to indicate the mode the receiver is in. AUTO (12): AUTO allows the receiver to store the 6 strongest stations onto push-buttons 1 through 6. Press AUTO until "AUTO" and "AS" appear on the display. The presets on the current band only will now be programmed with the 6 strongest frequencies. Presets on the other bands will not be changed.
Pressing AUTO again will delete the stations and default to the original preset stations.