OM2204 Warnings & Cautions - Section 22 Page 22-5 High Voltage Danger Plates and Caution Plates are attached to the doors of the Electrical Control Cabi- net. The High Voltage Plate is also attached to the blown grid housing, extended range housing, rectifier housing, inlet duct structure and rear hatch cover. A warning plate is located above the hydraulic sys- tem (APU) quick disconnect fittings in front of the hydraulic tank which provides instructions to the operator or technician for towing a disabled truck. This plate specifies the requirements for an auxiliary source of supply for hydraulic oil and the proper hookup. TEST STEERING AND BRAKE SYSTEM OPERA- TION BEFORE TOWING.
A wheel motor oil level decal is attached to the gear cover on both electric wheel motors. This decal stresses the fact that the truck must be on a level surface and parked for 20 minutes prior to checking the oil level. This is necessary in order to get an accurate reading.