Wiper combination switch When the start / stop button is in the "run" mode, the wipers and washers can work. If the start / stop button is not in the "run" mode during the action of the wiper, the wiper will stop immediately and return to the initial position when it is in the "run" mode the next time. If you want to select a gear, push or press the lever up or down: MIST:When the wiper control lever is turned to "mist" position and released, the wiper control lever will automatically jump back to "off" position. At this time, the front wiper wipes at a low speed once. When the wiper control lever is set to "mist" and held, the front wiper will continue to wipe until it is released.
OFF The wipers do not work. INT The front wiper is in intermittent wiping state. LO The front wiper wipes slowly. HI The front wiper wipes quickly. Intermittent time adjustment knob: rotate this knob to adjust the intermittent time of the front wiper. The intermission time is divided into four levels. Rotate the knob up to the highest level of 4 (the shortest intermission time), rotate the knob down to the lowest level of 1 (the longest intermission time), and the middle position is level 3 and level 2 in turn. Wiper combination switch (without rain sensor) Warning ●When the windshield is dry, water shall be sprayed first, and then the windshield shall be wiped.
It is forbidden to wipe the windshield without water. case of low temperature, make sure that the wiper blade is not frozen on the windshield. winter, the snow and ice on the wiper arm and wiper blade shall be removed in time, including the area involved in wiper operation. ① MIST Single wiper ② OFF Stop ③ INT Intermittent wiper ④ LO Low speed wiper ⑤ HI High speed wiper ⑥ Intermittent time adjustment knob 101