24. SERVICE PROCEDURE 3. Universal joint Apply grease to the grease fittings (2 places) shown by arrows. WARNING The undercover is heavy. Never try to open or close the cover when directly beneath it. When removing bolts 2 , carry out the work from the rear below the cover so that you can easily get out of the way. Remove inspection cover 3 of the undercover at the rear bottom of the chassis as follows. (1) Remove 2 bolts 1 at the front of the machine. (2) Support the cover with your elbow while gradually removing 2 bolts 2 at the rear of the machine. (3) Lower the cover gradually to open it.
Front of machine 24.2.22 DRAIN WATER FROM WATER SEPARATOR If float 2 of the water separator reaches red line 1 , drain the water as follows. 1. Loosen drain plug 3 of the water separator and drain the water until float 2 reaches the bottom. 2. If the machine is equipped with air bleed plug 4 , loosen air bleed plug 4 also to make it easier to drain the water. 3. Tighten air bleed plug 4 (on machines equipped with an air bleed plug), then tighten drain plug 3 . 4. If air was sucked in when the water was drained, bleed the air in the same way as for the fuel filter. For details, see “REPLACE FUEL FILTER CARTRIDGE (24.5 EVERY 500 HOURS SERVICE)”. 3-43