24. SERVICE PROCEDURE 24.4 EVERY 250 HOURS SERVICE 24.4.1 LUBRICATING 1. Lower the work equipment to the ground, then stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out. 1. Blade lift cylinder support yoke (4 places) 2. Blade lift cylinder support shaft (2 places) 3. Blade arm ball joint (3 places) 4. Brace screw (2 places) 5. Ripper tilt cylinder bottom pin (2 places) 6. Ripper lift cylinder bottom pin (2 places) 7. Ripper tilt cylinder rod end pin (2 places) 8. Ripper lift cylinder rod end pin (2 places) 9. Ripper arm pin (front) (2 places) 10.
Ripper arm pin (rear) (2 places) The ripper on the upper side is a multishank ripper, and the one on the lower side is a giant ripper. 3-45