24. SERVICE PROCEDURE 9. Tighten air bleed plug 3 , then push in the knob of feed pump 4 and tighten it. 10. After replacing the filter cartridge, start the engine and check that there is no leakage of oil from the filter seal surface. REMARK When only replacing the filter cartridge, it is enough to bleed the air from the air bleeding plug at the filter head. However, if the fuel piping is removed, bleed the air also from the air bleeding valve of the injection pump.
24.5.2 REPLACE TRANSMISSION FILTER ELEMENT AND TORQUE CONVERTER OIL FILTER ELEMENT Front Transmission filter ¤ WARNING Before opening the filter case, depress the brake pedal several times to release the pressure, then lock the brake pedal. If there is still pressure inside the filter, the oil may spurt out. Torque converter filter 1. Remove the floor cover on right side fender. 2. Remove bolts 1 and cover 2 is lifted up, then take out element 3 . Clean the inside of the case and the removed parts, and install new elements. Replace the O-ring at the same time. 3-54