24. SERVICE PROCEDURE 24.6.3 CLEAN STEERING CLUTCH CASE BREATHER 1. Remove bolts 1 , then remove cover 2 . 2. Remove breather 3 on steering clutch case, and wash out dust remaining inside with diesel fuel or flushing oil. 24.6.4 CHECK OIL LEVEL IN RECOIL SPRING, ASSIST CYLINDER CASE, ADD OIL 1. Remove bolts 1 , then remove cover 2 . When removing the cover, be careful not to let dirt or sand get in. 2. Insert a scale and check that the oil level is 70 – 80 mm (2.6 – 3.2 in) from the bottom edge of the inspection port. 3. If the oil level is low, add engine oil so that the oil. 24.6.5 GREASE TENSION PULLEY ASSEMBLY 1.
Using a grease pump, pump in grease through the grease fitting shown by arrow. 2. After greasing, wipe off any old grease that was pushed out. 3-59