. MAINTENANCE MAINTENANCE PROCEDURE Install Air Cleaner Element be inserted easily. 4 - 21 NOTIC Do not use any damaged gasket or seal or element with damaged pleats Cleaning the element or O-ring after one year has passed and using them again will caus e problems. Always re place them with new parts. The seal portion on imitation parts l acks precision, and allows the entry o f dust, which leads to damage of the engine. Do not use such imitation parts. Do not run the engine with the inne r element removed. It will cause damage to the en 1. C heck that there is no dirt or o il stuck to the seal portion of the n ew element or cleaned element. Wipe off any rt or oil. 2.
W hen the outer element has b een removed, check that the inn er element h as not come out of p osition and is t at an angle. If inner eleme nt is at an angle, insert your hand and push it in straight. r cleaner body. 3. P ush the outer element in stra ight with your hand when installin g it to the ai r cleaner he element is held and rocke d lightly up and down and to the l eft and right while pushing it in, th e element can NOTIC E When i nserting the element, if the rub ber at the tip is swollen or the outer element is n ot pushed in straight, a nd cover (3) is assembled by force to hook (2), there is danger that the hook and air cleaner body may be damaged, so be careful when assembling.
4. Install cover (3) as follows. 1) Align cover (3) with the element. 2) Hook the tip of hook (2) to the protruding part of the air cleaner body and lock it in position. 3) When locking hooks (2) in position, apply the hooks in turn on opposite sides (top, bottom, left, right) in the same way as when tightening bolts. 4) Always install cover (3) so that the evacuator is facing the ground. 5) When cover (3) is installed, check that the clearance between the air cleaner body and cover (3) is not too large. If it is too large, install again. 4.
In ) Align cover (3) with the ele ) Hook the tip of hook (2) t cleaner body and lock it in ) When locking hooks (2) in on opposite sides (top, bot as when tightening bolts. ) Always install cover (3) so ground. ) When cover (3) is instal