24 RENR5042-02 Troubleshooting Section (Table 9, contd) (1) The parameter can only be viewed. No changes are allowed. Parameters Worksheet (Table 10, contd) Note: A mistake in recording this information will result in incorrect passwords.
Table 10 (continued) (continued) System Configuration Parameters Parameter Available Range or Options Default Required Password “Direct Fuel Control Mode” “Installed” “Not Installed” “Not Installed” Factory “Last Tool to change Customer Parameters” Read Only (1) “Last Tool to change System Parameters” Read Only (1) “Aux Temp Sensor Installation Status” “On” “Off” “Off” None “Aux Press Sensor Installation Status” “On” “Off” “Off” None “Total Tattletale” Read Only (1) Engine Parameters “Low Idle Speed” “PTO Mode” “High Idle Speed” “Intermediate Engine Speed” “Engine Power Trim” “Maximum Engine Torque Limit” “Customer Password #1” “Customer Password #2” “FLS” “FTS” “Ether Control” “Air Shutoff” “Maintenance Indicator Mode” “PM1 Interval” “Throttle Position Sensor” “Coolant Level Sensor” Engine Parameters ECM Identification Parameters “Equipment ID” “Engine Serial Number” “ECM Serial Number” “Software Gp Part Number” “Software Gp Release Date” Selected Engine Rating “Rating Number” “Rated Power” “Rated Peak Torque” “Top Engine Speed Range” “Test Spec” “Top Engine Limit” “Engine Accel Rate”