UNDERCARRIAGE / Front Idler 10. Apply LOCTITE #503 to plug (8). Install plug (8) to bearing (1). CAUTION: The idler (7) assembly weight: 150 kg (330 lb) 6. Wind a nylon sling onto the idler (7) assembly. Hoist and turn over the idler (7) assembly. Install O-ring (4) to axle (5). IMPORTANT: For handling of the floating seal, refer to the Precaution for Floating Seal Handling section on W1-1-4. 7. Apply grease to O-ring of floating seal (3). Install the other floating seal (3) into idler (7) and bearing (1). : 29.5 N m (3.0 kgf m, 22 lbf ft) : 6 mm CAUTION: Yoke (9) weight: 25 kg (55 lb) 11. Wind a nylon sling onto yoke (9). Hoist yoke (9).
Align the bolt (10) holes on both bearings (1) and yoke (9). 12. Install yoke (9) to bearing (1) on both sides with bolts (10) (4 used). : 24 mm : 210 N m (21 kgf m, 155 lbf ft) 1 3 4 5 W157-03-05-005 IMPORTANT: Align the matching marks made when disassembling. 8. Evenly tap and install bearing (1) on the other into axle (5) by using a plastic hammer. Insert pin (2) by using a bar and hammer. 9. Add engine oil (API CD grade SAE30) through the plug (8) hole on bearing (1). Oil amount: 0.3 L (0.08 US gal.) W3-5-9 7 1