FRONT ATTACHMENT / Cylinder 4. Remove wire (9) from rod (8) of bucket cylinder (1). 8 1 CAUTION: Metal fragments may fly off when a hammer is used. Wear necessary protection, such as goggles, hard hats, etc in order to prevent personal injury. IMPORTANT: Fill hydraulic oil to specified level. Start the engine and check for any oil leaks. 5. Start the engine and operate the bucket lever. Align the hole on cylinder rod side with those of links (16, 18). Insert thrust plate (5) and pin (7). 6. Install bolt (4) to stopper (17) and pin (7) with nuts (6) (2 used). 9 W102-04-02-005 : 32 mm : 750 N m (76.5 kgf m, 553 lbf ft) IMPORTANT:
In case link (18) has been removed from the arm, insert thrust plate (19) when installing. IMPORTANT: After completing the work, operate the bucket cylinder several times to the stroke end and release the pressure in the circuit. W158-04-02-006 19 19 W178-02-11-289 18 18 W4-2-5 16 4 17 7 18 6