OPERATOR'S STATION CAB DOOR RELEASE LEVER 1 CAUTION: Open the cab door all the way until it se- curely locks in the latch on the side of the cab. To unlock the door from this position, push down on lever (1). OPENING UPPER FRONT WINDOW (Optional) M1J1-07-051 WARNING: Open or close the upper-front cab window only after pulling up the pilot control shut-off lever to the LOCK position. Failure to do so may allow the machine to move unexpectedly if a control lever is touched a part of the body by mistake, possibly re- sulting in personal injury or death. 2 1. Press lock release lever (2) at the upper center to release the upper front window lock. 3 NOTE: Use caution when releasing the lock.
The upper section of the upper front window will move approx. 10 cm in- ward. M1U1-01-028 2. Holding the upper and lower handles (one each) on the upper front window, pull the upper front window up and back until it securely catches into auto lock (4). CAUTION: Always secure lock pin (3) in the lock posi- tion after the upper front window is opened. 3. After confirming that the window securely catches into auto lock (4), slide lock pin (3) into the left bracket boss hole to lock the window in position. NOTE: When the upper front window is opened, the wiper and washer are inoperable. M1CC-01-115 4 M1CC-01-031 1-71