Operation 1. Check the power trim and tilt unit for any sign of oil leaks. 2. Operate each of the power trim and tilt switches on the remote control and en- gine bottom cowling to check that all switches work. 3. Tilt the outboard motor up and check that the tilt rod and trim rods are extend- ed completely. rods have retracted completely into the cylinders. ZMU04156 7. Activate the trim-up switch until the tilt rod is fully extended. Unlock the tilt sup- port lever. 1. Tilt rod 2. Trim rods 4. Use the tilt support lever to lock the mo- tor in the up position. Operate the tilt down switch briefly so the motor is sup- ported by the tilt support lever. 8. Tilt the outboard motor down.
Check that the tilt rod and trim rods operate smoothly. 1 EMU36581 Battery Check that the battery is in good condition, and fully charged. Check that the battery connections are clean, secure and covered by insulating covers. The electrical contacts of the battery and cables must be clean and properly connected or the battery will not start the engine. Refer to the battery manufacturer’s instruc- tions for checks for your particular battery. ZMU04155 1. Tilt support lever 5. Check that the tilt rod and trim rods are free of corrosion or other flaws. 6. Activate the tilt-down switch until the trim 39 2 1 ZMU03458 ZMU02635