Operation switch while the boat is moving. Adjust the outboard motor trim angle using the power trim and tilt switch. 1. Power trim and tilt switch 1 ZMU04145 1 UP 1. Trim operating angle EMU27884 Adjusting trim angle (Power trim and tilt) DN ZMU03522 EWM00753 WARNING 1. Power trim and tilt switch Be sure all people are clear of the out- board motor when adjusting the trim angle. Body parts can be crushed be- tween the motor and the clamp bracket when the motor is trimmed or tilted. To raise the bow (trim-out), press the switch ” (up). To lower the bow (trim-in), press the switch ” (down).
Make test runs with the trim set to different angles to find the position that works best for your boat and operating conditions. Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabil- ity or control problems. Improper trim angle can cause loss of control. EMU27911 Adjusting boat trim When the boat is on plane, a bow-up attitude results in less drag, greater stability and effi- ciency. This is generally when the keel line of the boat is up about 3 to 5 degrees.
With the bow up, the boat may have a greater tenden- If equipped with a power trim and tilt switch located on the bottom cowling, use the switch only when the boat is at a complete stop with the engine off. Do not adjust the trim angle with this 48