Optional Equipment - Section 6 OM6007 2/99 Page 6-16 Payload Meter II DISPLAYS AT START-UP 7. The display will show: POWER ON: This display indicates the Machine ID code where ‘‘xxx’’ indicates a value between 0 and 200. ALL external display lamps (Figure 6-2) will come on and stay on for approximately 27 seconds during the ‘‘Power-up Process’’. 8. The display will show: The ‘‘Power-up Process’’ will display the PLM settings. Each display will occur for approximately 3 seconds: This display indicates the Operator ID code where ‘‘xxx’’ indicates a value between 0 and 200. 9. The display will show: 1. The display will show:
This display indicates the Speed Limit setting where ‘‘xx’’ indicates a value between 0 and 99 km/h. In addition, a buzzer will sound and the following lamps will light for 3 seconds: Reception Pilot Lamp (2, Figure 6-1) 10. The display will show: Transmission Pilot Lamp (3, Figure 6-1) This display indicates the Option code setting. Memory Card Pilot Lamp (4, Figure 6-1) Refer to ‘‘Operator Check Mode, Setting the Op- tion Code’’ and to ‘‘Method of Operation’’ for more information on this function. 2. The display will show: The ‘‘xx’’ indicates the Truck Model. Refer to "Initial Setup of Payload Meter" for code defini- tions. 3. The display will show:
This display indicates the status of the Memory Card where: ‘‘Cd : - -’’ indicates Card Not Used, and ‘‘Cd : oo’’ indicates Card Is Used. NORMAL OPERATION If the truck engine is started before the preceding ‘‘Power-up Process’’ is completed, the display will shift to normal operation. 4. The display will show: This display indicates the status of the Inclinometer for the PLM, where If the engine is running when the payload meter starts up, only "o:XXX" and "d:XXX" will display before switching to normal operations. ‘‘CL : - -’’ indicates Inclinometer Not Used, and ‘‘CL : oo’’ indicates Inclinometer Is Used. 5. The display will show: This display indicates method of measurement where: "US :
- -" indicates METRIC Tons. "US : oo" indicates U.S. Tons. 6. The display will show: This function is not used. "SU : - -" indicates Switch 8 is up. "SU : oo" indicates Switch 8 is down.