OM6007.1 2/99 Optional Equipment - Section 6 Cab Radio Page 6-35 CAB RADIO To operate the Radio 7. Clock - If time-of-day is not on the display, press RCL (7). Press and hold SET button and at the same time press and hold TUNE until the correct hour appears. Press and hold SET button and at the same time, press and hold TUNE until the correct minute appears. (Seconds will set to 00 when adjusting minutes.) 1. Rotate the ON-OFF control (1) clockwise to turn the radio ON; rotate CCW (counter-clockwise) to turn radio OFF. Rotate VOL control clockwise to increase volume. Rotate VOL control CCW to de- crease volume. 2. AM/FM or WX - Press BAND switch (2) to select desired band.
(AM/FM or optional WX*, will be displayed depending on band choice.) Frequency - If radio is turned on and time is being displayed, press RCL to display frequency. NOTE: The last station heard on each band will be stored in memory. When switching back to that band, it will automatically return . * WX not available on all models. Stereo - The radio will automatically switch to stereo when tuned to an FM station broadcasting stereo, and the stereo indicator light ST will be displayed. 3. SEEK - Press SEEK / (3) to automatically search for the next higher / lower listenable station and stay there. It will find another station each time that the button is pressed. 8.
Balance - The left-right stereo balance is adjusted by rotating the BAL ance (8) control in the corre- sponding direction from the detent position. 4. Manual Tuning - Press and hold TUNE button (4) to increase frequency. Release as the desired frequency is approached. Press TUNE to decrease frequency. 9. Fade - Using the tab behind the BAL control, adjust the FAD E control (9) to the right to FAD E toward the rear speakers. Adjust it to the left to FAD E toward the front speakers. 5. Pushbuttons - Press one of the five pushbuttons (5) to recall a preset station. NOTE: BAL ance (8) and FAD E (9) controls have a detent position at the center for a balance of front to rear and left to right .
6. The following procedure will set-up pushbuttons: Locate a favorite station by using SEEK / or the TUNE / buttons. 10. & 11. Tone Rotate TRE control (10) towards left to decrease treble; rotate TRE control towards right to increase treble. Press SET pushbutton (6). The station frequency will flash 5 seconds or until set. Press the button that is desired to be established for that station. The radio will now return to that frequency each time that button is pressed and released. Rotate BAS control (11) to the right to increase bass; rotate BAS control to the left to decrease bass. NOTE: A total of fifteen stations can be preset - 5 AM, 5 FM, and 5 WX . NOTE:
Both controls have a detent position at the center for a balance of treble and bass .