OM2006.2 6/98 Safety - Section 2 Warnings and Cautions Page 2-23 A plate is located next to filler cap on fuel cap which specifies Diesel Fuel Only. Care should be taken to open cap slowly and bleed off pressure that may be in tank when removing filler cap. Operation and Maintenance Manual refered to is from Engine Manufacturer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Attached to the interior of battery box lid is a DANGER plate. This plate stresses the need to keep from making any sparks near the battery.
When another battery or 24VDC power source is used for auxiliary power, all switches must be ‘‘Off’’ prior to making any connec- tions. When connecting auxiliary power cables, posi- tively maintain correct polarity; connect the positive (+ ) leads together and then connect the negative (-) lead of the auxiliary power cable to a good frame ground. Do not connect to the negative post of the truck battery or near the battery box. This hookup completes the circuit but minimizes danger of sparks near the batteries. Sulfuric acid is corrosive and toxic. Use proper safety gear, goggles, rubber gloves and rubber apron when handling and servicing batteries. Avoid contact with skin, eyes or clothing.
In event of accident, immediately flush with plenty of water and call a physician. KEEP OUT OR REACH OF CHILDREN! These decals are placed on the top of the battery box and near the battery disconnect switches to indicate that the battery system (24VDC) is a NEGATIVE (-) GROUND system. This decal is placed above the battery disconnect switches on the right side of the battery box to indicate ‘‘Off’’ and ‘‘On’’ positions of the switches. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A caution plate is located on the side of the battery box.
These instructions must be followed when welding is done on the truck to avoid damage to the electronic components.