OM3006.3 04/98 Operation - Section 3 Instrument Panel and Indicators Page 3-23 R.H. Control/Indicator Panel (Pod) Ladder Light Switch The Control/Indicator Panel (3, Figure 3-6), located to the right of the steering wheel, provides an array of switches and controls. For detailed inrormation on this assembly, refer to ‘‘R.H. Control/Indicator Panel (Pod)’’ later in this sec- tion. The switch (6, Figure 3-6) turns the ladder lights ‘‘On’’ or ‘‘Off’’ after or before using ladder. A similar switch is available at ground level to turn the lader lights ‘‘Off’’ or ‘‘On’’.
Center Display Panel Head Light Switch The Center Display Panel (4, Figure 3-6) provides an array of gauges and monitors, with an odometer mod- ule) and a service/hour meter module. For detailed inrormation on this assembly, refer to ‘‘Center Display Panel’’ later in this section. The instrument panel lights, clear- ance lights, and the headlights are controlled by this three position rocker type switch (7, Figure 3-6). ‘‘Off’’ is selected by pressing the left side of the switch. Press the right side of the switch until it reaches the first detent (middle) to select the panel, clearance, and tail lights only.
Press the right side of the switch again, until it reaches the second detent to select headlights, as well as panel, clearance, and tail lights. L.H. Control/Indicator Panel (Pod) The Control/Indicator Panel (5, Figure 3-6), located to the left of the steering wheel, provides an array of indicator/monitor lights and three switches. For detailed inrormation on this assembly, refer to ‘‘L.H. Control/Indicator Panel (Pod)’’ later in this section. "OFF" These are ‘‘Rocker-type’’ switches. "ON" The ‘‘Off’’ and ‘‘On’’ positions are marked with these symbols.
BackUp/Deck Lights Switch The BackUp/Deck Lights Switch (8, Figure 3-6) allows backup lights to be turned ‘‘On’’ providing added visibility and safety when the Trans- mission Range Selector lever (see OPERATOR CONTROLS) is not in ‘‘REV’’ position. Mode Change Switches The Mode Change Switches (9 & 10, Figure 3-6) are to be used only by qualified service technicians.