OM3006.4 04/98 Operation - Section 3 Electronic Displays and Messages Page 3-39 c. The data for current payload is not indicated until the payload meter recognizes that the truck is being loaded. d. If after the current payload has been indicated and then additional material is now added to the load, the current payload data will not change. e. If data is not being recognized by "MOM", dump the load. Activate the dump cycle a second time and then assume normal operation. Note: For additional information regarding the Payload Meter, refer to the Option section of the service manual.
If the "LIGHTS OFF" area in i4 is touched then the back light of "MOM" is turned off and i4 is changed to a dark display. If any controller detects a fault, i4 is changed to the i6 warning message display automatically. After the operator has been informed of the fault code the action that should be taken is as follows: 1) Stop the truck in a safe location. 2) Apply the parking brake. 3) Confirm the presence of the fault code and the action code. 4) Follow the instructions of the action code. 5) Notify a qualified technician for repairs. The possible action codes are as follows: 5.
Screen i6, Warning Message Display Two faults can be displayed at one time along with their description and action. If three or more code are present the "FWD" and "REV" touch areas on the i6 screen can be used to view the other codes. The number that is as- signed to each code, is the order of occur- rence. Number 1 would be the oldest code and as the numbers increase the newer the code. If the fault code display in MOM is not a serious code requiring immediate action, the code can be cleared from the screen by touching the number of each fault located at the left side of the code number. However, this action only erases the code in MOM.
This is still an active fault, and the electronic display panel will keep indicating the action code. The central warning lamp will also remain activated. Once the fault code is erased from MOM the same code will not appear again until the code is recovered or unless the fault occurs again. When all of the faults are recovered or cleared from MOM the screen will return to i2, i3, or i4 automatically according to the truck condition. When a fault occurs in any of the controllers the operator is informed of this through the following method: a. MOM will display the fault code and the action code along with a description of each. b.
The electronic display in the instrument panel will also display the action code. c. The central warning lamp is turned on and off as a warning alarm. In certain cases the warn- ing buzzer is also activated. If the fault is with a component or system that also has a warning lamp, this indication will also be activated at the same time. Code Description 01 Go to shop after work. 02 Go to shop right now. 03 Reduce engine / machine speed. 04 Stop safely / shut off engine. 05 Wait with engine low idle. 06 Start engine / keep low idle. 07 Keep body seated.