OM6005 11/01 Optional Equipment - Section 6 Payload Meter II Page 6-5 LIGHTS, SWITCHES, and COMPONENTS On The Face Of The Payload Meter (Refer to Figure 6-1) 6. Calibration/Clear Switch Used to calibrate the machine when the condi- tions regulate this action. Also used with the TOTAL/SFT switch to clear total payload and overall number of cycles. 1. Display Panel Digital display area for the data being recorded in memory. This will include items such as: 7. Total/Shift Switch · Payload Used to display payload and overall number of cycles each time the load is dumped. Will dis- play the error codes.
This switch is also used with the CALIBRATION/CLEAR switch to clear total payload and overall number of cycles. · Date & Time · Cycles · Travel Distance · Fault Codes and Warnings 8. Light/Increment Switch 2. Reception Pilot Lamp (Rx Busy) Used to change the digital increments or units for the various displays. Also used to adjust the brightness of the lights on the monitor display. This light will illuminate for 3 seconds when the system is powered up. It will then be lit when- ever the computer is communicating. 9. Memory Card 3.
Transmission Pilot Lamp (Tx Busy) Used to receive data from the payload meter memory to this card which can then be used to transfer the data into a personal computer. This enables the memory to be downloaded and saved when a personal computer is not avail- able. This light will illuminate for 3 seconds when the system is powered up. It will then be lit when- ever the memory is being downloaded to a per- sonal computer. 4. Memory Card Access Lamp (CARD Busy) This light will illuminate for 3 seconds when the system is powered up. It will also be lit when- ever the memory data is being downloaded to the memory card. 10. Cover Protective cover for the Memory Card.
Do not open or place foreign objects in slot. 11. Diagnostic/Download Port 5. Mode Switch Connector port that is used for downloading the memory data to a personal computer. This switch is used to select the mode or sys- tem that will allow a function to be performed. This may include: · Various settings or corrections to the display · Memory card downloading · Clearing data · Display of Abnormalities or Warnings · Setting the speed limit · Setting the date and time