Optional Equipment - Section 6 11/01 OM6005 Page 6-18 Payload Meter II DISPLAYS AT START-UP 7. The display will show: This display indicates the Machine ID code where "xxx" indicates a value between 0 and 200. POWER ON: All external display lamps (Figure 6-2) will come on and stay on for approximately 27 seconds during the "Power-up Process". 8. The display will show: This display indicates the Opera- tor ID code where "xxx" indicates a value between 0 and 200. The "Power-up Process" will display the PLM II settings. Each display will occur for approximately 3 seconds: 9. The display will show: This display indicates the Speed Limit setting where "xx" indicates a value between 0 and 99 km/h.
1. The display will show: In addition, a buzzer will sound and the following lamps will light for 3 seconds: 10. The display will show: Reception Pilot Lamp (2, Figure 6-1) This display indicates the Option code setting. Transmission Pilot Lamp (3, Figure 6-1) Memory Card Pilot Lamp (4, Figure 6-1) 2. The display will show: Refer to "Operator Check Mode, Setting the Option Code" and to "Method of Operation" for more information on this function. The "xx" indicates the Truck Model. Refer to "Initial Setup of Payload Meter" for code definitions. 3. The display will show: This display indicates the status of the Memory Card where:
NORMAL OPERATION If the truck engine is started before the preceding "Power-up Process" is completed, the display will shift to normal operation. "Cd : - -" indicates Card Not Used, and "Cd : oo" indicates Card Is Used. 4. The display will show: If the engine is running when the payload meter starts up, only "o:XXX" and "d:XXX" will display before switching to normal operations. This display indicates the status of the Inclinometer for the PLM II , where "CL : - -" indicates Inclinometer Not Used, and "CL : oo" indicates Inclinometer Is Used. 5. The display will show: This display indicates method of measurement where: "US : - -" indicates METRIC Tons. "US : oo" indicates U.S. Tons. 6.
The display will show: This function is not used. "SU : - -" indicates Switch 8 is up. "SU : oo" indicates Switch 8 is down.