24. SERVICE PROCEDURE 24.2.7 REPLACE BUCKET TEETH (VERTICAL PIN TYPE) Replace the point before the adapter starts to wear. WARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. 1. Set a block at the bottom face of the bucket so that it is possible to knock out the pin of tooth , then check that the work equipment is in a stable conditon, and lock the safety lock lever. Set so that the bottom face of the bucket is horizontal. 2.
Use a hammer and drift to knock out lock pin (If the drift is set against rubber pin lock when it is hit, the rubber pin lock may break. Set it against the back of the pin). 3. After removing lock pin and rubber pin lock , check them. If lock pins and rubber pin locks with the following defects are used, the point may come off the bucket. Replace them with new ones. The lock pin is too short PC130/150LGP-6K ENG 3-35