29. INTRODUCTION OF OPTIONAL PARTS AND ATTACHMENTS This table lists the combination of attachments which can be installed to the standard arm, short arm and long arm. NOTE: When a long arm is installed, if the bucket is pulled in fully to the front of the machine it may hit the chassis; when digging at an angle, the bucket may hit the undercarriage, so be careful when carrying out these operations. PC150LGP-6K BUCKET AND ARM COMBINATION These charts based on over-side stability with fully loaded bucket at maximum reach. Please consult your local dealer for the bucket range available in your region.
Material weight up to 1,5 t/m 3 Material weight up to 1,2 t/m 3 - Not for use PC130/150LPG-6K ENG 5-12 Width Weight (Without SAE, PCSA CECE Without side cutters With side cutters side cutters) 2.1 m 2.5 m 2.9 m 0.24 0.22 450 mm 575 mm 314 kg 0.28 0.26 550 mm 675 mm 339 kg 0.35 0.33 650 mm 775 mm 367 kg 0.47 0.43 750 mm 875 mm 419 kg 0.59 0.53 900 mm 1025 mm 469 kg 0.68 0.61 1000 mm 1125 mm 497 kg 0.76 0.69 1100 mm 1225 mm 525 kg 0.84 0.76 1200 mm 1325 mm 563 kg