11. EXPLANATION OF COMPONENTS Manual setting 1. When the time is displayed depress clock switch for 2.5 sec or more. 2. " " flashes. 3. Pressing H switch increases hours and pressing M switch in- creases minutes. If switch or is pressed for 2.5 seconds or more, hours or minutes increase continuously. 4. When the correct time is reached, press clock switch . This com- pletes clock setting. Correct time setting 1. When the time is displayed, depress the clock switch for 2.5 sec or more. 2. " " flashes. 3. When SET switch is pressed, the hour is rounded off for 0 to 14 minutes and rounded up for 45 to 59 minutes.
(Examples) 10:14 becomes 10:00 (rounded off) 10:45 becomes 11:00 (rounded up) When SET switch is pressed at the time signal or standard clock, the correct time is obtained. 4. When the correct time is reached, press clock switch . This com- pletes clock setting. If the machine has a fault, error information appears while the start- ing switch is ON. The monitor flashes and displays all error informations sequentially. If any of these monitors flash, see "16.7.4 ELECTRONIC CONTROL SYSTEM". 6. SERVICE METER This meter shows the total operation hours of the machine. Set the periodic maintenance intervals using this display.
The service meter advances while the engine is running - even if the machine is not travelling. The meter will advance by 1 for each hour of operation regardless of the engine speed. PC130/150LGP-6K ENG 2-11 Monitor indications Error mode E02 TVC valve system error E03 Swing brake system error E05 Governor system error CALL Non-operating error