11. EXPLANATION OF COMPONENTS 4. POWER MAX./SWIFT SLOW-DOWN SWITCH During operations, the digging power can be increased and the speed reduced by a one-touch operation of the knob button (single click while pushing). Power max. (power up) lights up: When the working mode is heavy-duty and general operation modeonly, the power can be increased approx. 30% (genral operation mode) and the set pressure can be increased approx. 9% (heavy-duty operation mode and general operatonmode) while the knob button is being pressed. Even if the knob button continues to be pressed, the increase in power finishes after approx. 8.5 sec. Swift slow-down (speed down) lights up:
When the working mode is heavy-duty operation and general operation mode only, the speed is reduced approx. 35% for heavy-duty operation mode and approx. 25% for general operation mode, and the set pressure is increased approx. 9% for heavy-duty operation mode and general op- eration mode. When the engine is strated, the power max. lamp lights up. Each time the set switch is pressed, the mode is switched. 5. ACTIVE MODE SWITCH (SELECTOR SWITCH) The active mode is effective for quick levelling operations of deep digging and loading operations. ON lights up: Active mode ON ON goes out: Active mode cancelled The ON lamp is off when the engine is started.
If it is turned ON (lights up), ti is possible to enter the active mode from any working mode. Even when it is turned ON (lights up), the working mode display does not change. When the lamp goes out, the system returns to the original working mode. NOTICE When using the breaker, do not set to the active mode. PC130/150LGP-6K ENG 2-14