OPERATION MACHINE OPERATIONS AND CONTROLS Seat Belt 3 q Before fitting the seat belt, check that there is no abnormality in the belt mount bracket or mounting belt. If it is worn or damaged, replace the seat belt. q Even if no abnormality can be seen in the belt, replace the seat belt every 3 years. The date of manu- facture of the belt is shown on the back of the belt. q Always wear the seat belt during operations. q Fit the seat belt so that it is not twisted. Fastening and Removing This seat belt has a wind-in device, so it is not necessary to adjust the length.
Fastening Seat Belt Hold grip (2) and pull the belt out from wind-in device (1), check that the belt is not twisted, then insert tongue (3) into buckle (4) securely. When doing this, pull the belt lightly to check that it is properly locked. Removing Belt Press button (5) in buckle (4), and remove tongue (3) from buckle (4). The belt is automatically wound in, so hold grip (2) and return the belt slowly to wind-in device (1). REMARK For machines with a suspension seat,adjust the position of the seat, then adjust tether belt (1). Install the tether belt so that it is tensed when no one is sitting in the seat. (Only machines equipped with suspension seat) 3-69 WARNING