OPERATION MACHINE OPERATIONS AND CONTROLS 3. Lower the bucket horizontally until the bottom touches the ground. 4. Set safety lock lever (3) in the LOCK position. 5. Stop the engine. For details of the procedure for stopping the engine, see “STOPPING THE ENGINE (3-83)“. CHECK AFTER SHUT OFF ENGINE 3 Use the machine monitor to check engine water temperature (1), engine oil pressure (2), and fuel level (3). REMARK After stopping the engine, if the starting switch is turned within approx. 10 seconds to the ON or START position to start the engine again, the monitor display is not reset, and the screen before the starting switch was turned OFF is displayed. 3-105