OPERATION DETAILED CONTROLS AND GAUGES Fuel Gauge This meter (4) shows the amount of fuel in the fuel tank. The green range should light up during operations. If only the red range lights up during operations, there is less than 46 liters of fuel remaining, so check and add fuel. Red range (A) lights up: Fuel gauge monitor lamp (B) flashes. After the starting switch is turned to the ON position, the correct level is not displayed for a short time, but this does not indicate any abnormality. When the engine is stopped, turn the starting switch ON and check that each item and the meters light up. (a): Red range (b):
Green range Service Meter This monitor (5) displays the total amount of time that the machine has been operated. Use the time display to set the maintenance intervals. If the engine is running, even if the machine is not moving, the ser- vice meter advances. The service meter advances by 1 for every hour that the engine is running, regardless of the engine speed. Display This display (5) shows the service meter. If any abnormality occurs, (6) indicates the content of the failure. REMARK If the machine has a fault, error information appears while the starting switch is ON. The monitor flashes and dis- plays all error information sequentially.
If any of the above displays flashes, see “Electronic Control System (3-132)“. 3-13 Monitor display Failure mode E02 Error in pump control system E03 Error in swing brake system E05 Error in governor system E06 Error in electrical system