OM5015 03/01 Specifications - Section 5 Component Descriptions Page 5-3 SPECIFICATIONS These specifications are for the standard 930E Truck. Customer Options may change this listing. ENGINE SERVICE CAPACITIES . . . . . . . . . . U.S. Gallons . . . . . Liters Crankcase (Includes lube oil filters) QSK60-C . . . . . . . . . . . 74 . . . . . . 280 Cooling System . . . . . . . . 157 . . . . . . 594 Fuel . . . . . . . . . . . . . 1200 . . . . . . 4542 Hydraulic System . . . . . . 350 . . . . . . 1325 Wheel Motor Gear Box . 20/Wheel . . . 76/Wheel Cummins QSK60 Number of Cylinders . . . . . . . . . . . . . . 16 Operating Cycle . . . . . . . . . . . . . . 4-Stroke Rated Brake HP .
2700HP (2014 kW) @ 1900 RPM Flywheel HP . . . . . . . . . . . 2550HP (1879 kW) Weight (Dry)* . . . . . . . . 19,515 lbs. (8852 kg) * Weight does not include Radiator, Sub-frame, or Alternator AC ELECTRIC DRIVE SYSTEM HYDRAULIC SYSTEM Hoist & Brake Cooling Pump: . . . . Tandem Gear Output . . . 270 GPM (1022 l/min) @ 1900 RPM . . . . . . . . . . . . . and 2500 psi (17 237 kPa) Steering/Brake Pump: Press. Compensated Piston Output . . . . 65 GPM (246 l/min) @ 1900 RPM . . . . . . . . . . . . . and 2750 psi (18 961 kPa) Relief Pressure- Hoist . . . . . 2500 psi (17.2 MPa) Relief Pressure- Steering/Brake 2750 psi (22.4 MPa) Hoist . . . . . . . Two 3-Stage Hydraulic Cylinders Tank . . . .
Vertical - Cylindrical, Non-Pressurized Tank Capacity . . . . . 250 U.S. Gal. (947 Liters) Filtration . . . . . . . In-line replaceable elements Suction . . . . . . . Single, Full Flow, 100 Mesh Hoist & Steering Filters . . . Beta 12 rating = 200 . . . . . . . . . . . . Dual, In-Line, High Pressure AC/DC Current Alternator . . . . . . . . General Electric GTA - 34 Integral Cooling Fan . . . 2500 cfm (71 m 3 /min) AC Thermally Mod. Dual Fan . . . . . . . . . . . . . . . 12,000 cfm (340 m 3 /min) Motorized Wheels . . AC Induction Traction Motors . . . . . . . . . . . . . . . Wheel Slip/Slide Control Standard Gear Ratio* . . . . . . . . . . . 31.50:1 Maximum Speed . . . . . .
40 MPH (64.5 km/h) * NOTE: Wheelmotor application depends upon GVW, haul road grade, haul road length, rolling resistance, and other pa- rameters. Komatsu & G.E. must analyze each job condition to assure proper application . DYNAMIC RETARDING Electric Dynamic Retarding . . . . . . . Standard Maximum Retarding . . . . . . 5400 HP (4026 kW) Continuous . . . . . . . . . . 3300 HP (2460 kW) Continuously Rated High-density Blown Grids with Retard at Engine Idle and Retard in Reverse Propulsion. SERVICE BRAKES All Hydraulic Actuation . . . . with Traction System . . . . . . . . . . . . . . Wheel Slip/Slide Control Front & Rear Oil-Cooled Multiple Discs . . . . . . . . . . . . . . . . . . .
at Each Wheel. Total Friction Area /Brake 15,038 in 2 (97 019 cm 2 ) Maximum Apply Pressure . 2500 psi (17 238 kPa) BATTERY ELECTRIC SYSTEM Batteries - . . . . . . . . . . . . bumper-mounted 4 x 8D & 2 x 30H 12 Volt Batteries in Series/Parallel . . . . . . . . . . . . . 220 Ampere-Hour Capacity . . . . . . . . . . . . . . . With Disconnect Switch Alternator . . . . . . . 24 Volt, 240 Ampere Output Lighting . . . . . . . . . . . . . . . . . . . 24 Volt Starters (2) . . . . . . . . . . . . . . . . . 24 Volt STEERING Turning Circle (SAE) . . . . . 97 ft. 4 in. (29.67 m) Twin hydraulic cylinders with accumulator assist to provide constant rate steering.
Emergency Power Steering automatically provided by Accumulators